Microsoft Word - Document1

‘ g Power Tool Division BLS RASH OZ Rockwell International DATED IM-11-15-65 14” WOOD CUTTING AND METAL—WOOD CUTTING A band saw requires a reasonable amount of care and attention in order to insure perfect per- formance and accurate work. No matter how good a machine a manufacturer may make, it will not do its best work unless the user takes the trouble to ” familiarize himself with the proper method of using the machine and setting the adjustments, and to learn what is necessary for best results. It takes but à few minutes to read these 1astructions, and it may save hours of trouble or delay later. The gear case of the metal-wood cutting Band Saw contains « double clutch which permits instant change-over from gear drive to direct drive by simply shifting the clutch. METAL-WOOD & WOOD CUTTING MODELS Remove the carton and weatherproof covering and place stand or bench. Loosen table

‘ g Power Tool Division BLS RASH OZ Rockwell International DATED IM-11-15-65 14” WOOD CUTTING AND METAL—WOOD CUTTING BAND SAW A band saw requires a reasonable amount of care and attention in order to insure perfect per- formance and accurate work. No matter how good a machine a manufacturer may make, it will not do its best work unless the user takes the trouble to ” familiarize himself with the proper method of using the machine and setting the adjustments, and to learn what is necessary for best results. It takes but à few minutes to read these 1astructions, and it may save hours of trouble or delay later. The gear case of the metal-wood cutting Band Saw contains « double clutch which permits instant change-over from gear drive to direct drive by simply shifting the clutch. SETTING UP METAL-WOOD & WOOD CUTTING MODELS Remove the carton and weatherproof covering and place saw.on stand or bench. Loosen table clamp and set table horizontal. The table insert and the tapered pin for the table alignment hole at the end of the table slot, . togetber with the hexagon wrench for the euides. will be found in the envelope attacned tn the saw, ‘the table pin should be tapped in'o place with…