° Tuning. Repair * ne

+ Overhagil ¢ Modificatioy Introduction 1-1 Tools and equipment 2-1 Carburetor fundamentals 3-1 Carburetor identification 4-1 Troubleshooting 5-1 Carburetor removal and installation 6-1 Overhaul and adjustments Part A Overhaul tools and preparation 7A-1 PartB One-barrel models: 1M, 1MV, 1ME, 1MEF 7B-1 PartC Two-barrel models: 2G, 2GC, 2GV 7C-1 Part D Quadrajet four-barrel models: 4MC, 4MV, M4MC, M4MCA, M4MEA, M4MED, M4MEF, Dualjet two-barrel models: M2MC, M2ME, E2MC, E2ME 7D-1 PartE Varajet two-barrel models: 2SE, E2SE 7E-1 Selection and modification 8-1 Conversion factors 8-20

--- TABLE DES MATIERES / CONTENTS --- Contents Chapter 1 Introduction 1-1 Chapter 2 Tools and equipment 2-1 Chapter 3 Carburetor fundamentals 3-1 Chapter 4 Carburetor identification 4-1 Chapter 5 Troubleshooting 5-1 Chapter 6 Carburetor removal and installation 6-1 Chapter 7 Overhaul and adjustments Part A Overhaul tools and preparation 7A-1 PartB One-barrel models: 1M, 1MV, 1ME, 1MEF 7B-1 PartC Two-barrel models: 2G, 2GC, 2GV 7C-1 Part D Quadrajet four-barrel models: 4MC, 4MV, M4MC, M4MCA, M4MEA, M4MED, M4MEF, E4MC, E4ME Dualjet two-barrel models: M2MC, M2ME, E2MC, E2ME 7D-1 PartE Varajet two-barrel models: 2SE, E2SE 7E-1 Chapter 8 Selection and modification 8-1 Conversion factors 8-20 Glossary GL-1 Index IND-1 RE ae GAUGE FROM TOP OF CASTING TO TOP OF FLOAT — GAUGING POINT 3 16" BACK FROM END OF FLOAT AT TOE (SEE INSET) © HOLD RETAINE! FIRMLY IN PLACE (INSET) GAUGING POINT (3 16" BACK FROM TOE) Onèmiove FLOAT AND BEND FLOAT ARM UP OR DOWN TO ADJUST + Ovisuauv CHECK FLOAT ALIGNMENT AFTER ADJUSTING PUSH FLOAT DOWN LIGHTLY AGAINST NEEDLE